How to measure card centering
Measure the two borders in each direction and divide the wider one by their sum; the worse direction is the one that counts. The arithmetic is easy. Placing the lines is the hard part.
Updated November 17, 2026
Centering is the one part of a card’s condition for which PSA publishes a number, so it is the part you can check against PSA’s own figure at home. This page shows the arithmetic, two ways to take the measurement, and how exact each one can be.
What is measured
On the front of a card with a border, four widths matter: the border on the left, on the right, at the top and at the bottom. Each is measured from the card’s cut edge to where the printed frame begins.
- Left to right: the wider of left and right, divided by left plus right.
- Top to bottom: the wider of top and bottom, divided by top plus bottom.
Take a left border of 3.3 mm and a right border of 2.7 mm. Then 3.3 ÷ (3.3 + 2.7) = 0.55, which is written 55/45. These widths are an example, not a real card.
PSA’s grading standards, read on November 16, 2026 and found unchanged on November 17, 2026, say PSA determines centering by comparing the measurements of the borders from left to right and top to bottom, and that the centering is designated “as the percent of difference at the most off-center part of the card”. We read that as: the worse of the two directions counts.
The back has its own tolerance: wider than the front’s for grades 10 to 4, the same 90/10 for grades 3 to 1.5. We measure it the same way. PSA’s figure for each grade is on PSA’s centering standards.
A card with art to the edge has no border, so there is nothing to measure this way.
With a ruler
A ruler with half-millimetre marks is enough to try it. It also shows how fine the measurement has to be.
Take a card with a 3 mm border on each side, so 50/50, again as an example. Read one of the two borders half a millimetre too wide and the sum becomes 3.5 ÷ (3.5 + 3.0) = 0.538, or 53.8/46.2. Half a millimetre moved the result by almost four points. PSA’s front figures for a 10 and a 9, approximately 55/45 and approximately 60/40, are five points apart, so a ruler is too coarse to say much near a limit.
Callipers that read to a tenth of a millimetre are finer: 0.1 mm on a 3 mm border moves the result by about 0.8 points.
With a photo
In principle a photo can be finer than a ruler: a standard card is about 63 mm wide, so with the card 1,000 pixels wide in the picture one pixel is about 0.06 mm. Whether a real phone photo reaches that has not been tested. Every figure in this section comes from a simulation or a formula, not from photos of cards.
Two things you control matter most.
The photo has to be straightened. Unless the camera is exactly square to the card, the borders come out wrong. In our own simulation, straight horizontal and vertical lines placed exactly on a picture rotated by 2 degrees were up to 0.7 to 1.4 points off, and on a picture tilted by 5 degrees up to 1.0 to 1.4 points off (camera about three card-lengths away; closer makes it worse). Straightening the picture from the card’s four corners removes the error from the angle, as long as the corners sit exactly on the card’s corners. In our tests on drawn cards, corners placed one pixel off left up to about half a point of error, and corners four pixels off up to 1.4 points on a small picture. The centering check offers straightening as its first step, and says so in the result when it was skipped.
The card has to be large in the picture. Every line sits on a pixel. With side borders of about 5% of the card’s width and a card near 50/50, one line placed one pixel off moves the ratio by about:
Swipe or scroll sideways to see the whole table.
| Card width in the picture | One line, one pixel off |
|---|---|
| 400 pixels | 1.3 points |
| 800 pixels | 0.6 points |
| 1,200 pixels | 0.4 points |
| 2,400 pixels | 0.2 points |
Two lines each one pixel off, in opposite directions, move it about twice as much. So let the card fill most of the frame, with a little background showing on every side. With borders of about 5% of the width, a card at least about 1,000 pixels wide keeps a one-pixel slip of one line to about half a point; narrower borders need a larger picture.
A real photo adds glare, soft focus, rounded and worn corners and, on some cards, a border that fades into the art. Expect it to be less exact than these figures.
Taking the photo. Lay the card flat on a plain, dark, matt surface, in even light with no glare on it, and hold the phone straight above it. A sleeve or a top loader adds glare and edges of its own; we have not tested either.
Reading the result
A measurement near a limit cannot settle anything. A card that reads 54/46 with a ruler may be a 55.5/44.5 card: that is a fifth of a millimetre on a 3 mm border. The centering check says “too close to call” when the result is within about a point of PSA’s figure, and within more than that on a small picture.
PSA’s own standards also leave the decision near the limit to the grader. The leeway on the front and the centering note are on PSA’s centering standards.
A centering measurement is not a grade. It tells you about one thing a grader looks at, and nothing about the corners, the edges or the surface.
Sources
- How PSA measures centering, and PSA’s figures: PSA’s grading standards, the grade definitions and the entry “OC (Off Center)” under “Qualifiers”, read on November 16, 2026 and found unchanged on November 17, 2026.
- The figures on rotation, tilt and pixels: CardCaliper’s own work of November 16, 2026. They come from a simulated camera looking at a card of known centering and from the formula for a line placed one pixel off; the tool’s measurements on drawn stand-in pictures agree with them. No real card and no phone photo was measured.